940 Series

Tool 942i1224B

When marking depth varies between identical parts, the problem is usually tip geometry consistency, not your setup.

The 942i1224B delivers a 0.024" tip diameter with 90-degree included angle geometry.
The AlTiN coating extends tool life in harder alloys where uncoated carbide would wear quickly, maintaining that tight tip dimension through more parts.
Single flute design evacuates chips cleanly from narrow grooves without packing.
This geometry works across metals and composites where mark width consistency matters more than speed.
The 90-degree angle provides the right balance between sharp detail and structural strength at the tip.
Each part gets the same mark depth at the same Z-axis position because the tip geometry stays within tolerance longer.