100 Series

Tool 100i1000M030A

Most shops know the sound of an end mill losing its edge mid-cut. The 100 Series is built to hold that edge longer in steel, iron, titanium, and nickel alloys through consistent performance rather than peak numbers.

Four flutes spread chip load evenly across the cutting diameter.
When you're profiling steel or roughing titanium, that even distribution keeps each flute working at the same rate instead of overloading one edge.
The TiAlSiN coating adds a thermal barrier that matters most when cutting generates heat.
Think interrupted cuts in steel or continuous passes through work-hardened stainless.
The R0.03" corner radius strengthens the cutting edge without sacrificing surface finish.
Sharp enough for clean entry, radiused enough to resist chipping when the cut gets aggressive.
This geometry works particularly well in side milling operations where the corner sees the most stress.