100 Series

Tool 100i625S030A

Interrupted cuts and tough alloys beat up sharp corners. This 0.625" diameter end mill carries a 0.03" corner radius specifically to handle those conditions in steel, iron, titanium, and nickel alloys.

The radius strengthens the cutting edge where stress concentrates most.
In profiling operations on hardened steel or interrupted cuts in cast iron, that extra edge support translates to longer tool life and fewer mid-cut failures.
Four flutes keep chip evacuation steady while distributing cutting forces across multiple edges.
TiAlSiN coating adds another layer of protection against the heat and chemical wear that comes with machining nickel alloys and titanium.
The coating lets you maintain surface speeds without compromising edge integrity, particularly important when cycle time matters but tool changes don't fit the schedule.