100 Series

Tool 100m080LA

8-inch cuts put real stress on an edge. The 100m080LA handles that stress by spreading chip load across four flutes, keeping each cutting edge from overworking as you push through steel, iron, titanium, and nickel alloys.

TiAlSiN coating adds wear resistance where it matters most.
The aluminum content creates a barrier against heat buildup during extended cuts, while the silicon component maintains lubricity when chips start sticking.
In heavy roughing operations, that combination keeps the edge cutting instead of rubbing.
The R0.15" corner radius strengthens the cutting edge at the point where most failures start.
Sharp corners concentrate stress, but this radius distributes cutting forces across a broader contact area.
The result is an edge that stays intact through interrupted cuts and varying material hardness.
Four flutes maintain consistent chip evacuation even at depth.
Run-to-run performance stays predictable because each flute carries the same load.