110 Series

Tool 110i125FA

In thin-wall work and finishing passes on stainless, edge chipping kills your surface finish before heat becomes the problem. The 110i125FA addresses this with an R0.004" corner radius that distributes cutting forces across more carbide material instead of concentrating them at a sharp corner.

The 110 Series runs three flutes for heat management in steel, iron, titanium, and nickel alloys.
The TiAlSiN coating on this quarter-inch end mill adds oxidation resistance at higher cutting temperatures while maintaining the sharp edge geometry these materials demand.
In stainless work where built-up edge formation can ruin a part, the coating chemistry helps chips release cleanly from the flute.
The slight corner radius extends tool life in interrupted cuts without compromising edge sharpness in continuous operations.