110 Series

Tool 110i125LF

Small diameter work in demanding alloys leaves little margin for heat buildup or chatter. The corner radius holds up better than a sharp edge when interrupted cuts try to chip it.

The 110i125LF is a 3-flute solid carbide end mill at 0.125" diameter for steel, iron, titanium, and nickel alloys.
Three flutes give the chip clearance needed when heat management trumps material removal rate.
The R0.004" corner radius strengthens the cutting edge against the kind of microfractures that kill small tools in interrupted cuts or when entering hardened zones.
In thin-wall titanium or when profiling stainless components, this geometry stays predictable where a sharp corner would deteriorate.
The uncoated substrate runs clean in applications where coating buildup would interfere with tight tolerances or fine surface finishes.