200C Series

Tool 200Cm050FC

The 200Cm050FC is a 5mm 3-flute chipbreaker end mill from the 200C Series, for deep pockets and full-width slots in aluminum. The F in the part number means a reduced neck behind the flutes, so you reach 21mm from the tip, deeper than its 10mm length of cut.

The chipbreakers cut the chip short before long, continuous chips can pack against the wall in a deep pocket or a full-width slot.
Sonic sets the chipbreaker pattern so you can run a higher feed rate than a smooth flute and still get a good wall finish.
The end is center cutting, so you can ramp and plunge.
You clamp a 6mm shank, stiffer than a 5mm one, and get the reach from the neck.
A 0.1mm corner radius holds up better than a sharp corner and leaves a 0.1mm fillet where the wall meets the floor.
TiB2 resists aluminum sticking to the edge, so you can run higher speeds and feeds than with an uncoated tool.