200 Series

Tool 200i1000L060C

Built-up edge turns a good aluminum job into scrap fast. The material welds to the cutting edge, then breaks away unpredictably, leaving a finish that looks more beaten than machined. Most cutters fighting aluminum lose this battle in the first few passes.

The 200 Series puts three flutes to work on aluminum, copper, and plastics.
Lower chip load per tooth compared to two-flute designs means less heat generation at the cutting zone where adhesion starts.
The TiB₂ coating on this tool adds another layer of protection against material pickup during demanding cuts where spindle power and feed rates push the limits.
The R0.06" corner radius distributes cutting forces over a larger area than sharp corners, extending tool life in interrupted cuts.
High helix geometry moves chips out before they become a thermal problem.