200 Series

Tool 200i125FC

Small diameter aluminum work amplifies every mistake. Heat builds faster, chips pack tighter, and a welded edge happens in seconds instead of minutes. The margin for error shrinks with the cutter diameter.

The 200i125FC runs a 0.125" cutting diameter with three flutes and TiB₂ coating.
Three flutes distribute cutting load across more edges while keeping individual chip loads manageable.
Critical when thermal mass is limited.
The TiB₂ coating adds hardness without the aluminum affinity problems you get with AlTiN coatings.
A 0.004" corner radius strengthens the cutting edge against chipping while maintaining clean entry into the cut.
This geometry works for aluminum, copper, and plastics where precision matters and rework costs more than the tool.