200 Series

Tool 200i125LC

Small diameter aluminum work amplifies every mistake. Heat builds faster, chips pack tighter, and there's less carbide mass to absorb the punishment. A standard end mill geometry that works fine at half-inch diameter becomes a liability at eighth-inch.

The 200i125LC runs a 3-flute configuration at 0.125" diameter to distribute chip load across more cutting edges while maintaining aggressive feed rates.
The geometry keeps individual tooth engagement light enough to prevent aluminum adhesion.
TiB₂ coating adds wear resistance for extended tool life in demanding passes where you can't back down on parameters.
Corner radius of 0.004" strengthens the cutting edge without compromising sharpness.
Heat treats the edge better than a sharp corner under load.