200 Series

Tool 200i250M015C

Aluminum work hardens fast under a dull edge. Quarter-inch work amplifies this problem because smaller tools run higher surface speeds, generating more heat per unit of cutting edge. The margin for error gets thin quickly.

The 200i250M015C handles aluminum, copper, and plastics through controlled chip load distribution.
Three flutes reduce load per tooth compared to two-flute designs while maintaining production feed rates.
The 0.015" corner radius strengthens the cutting edge against chipping while leaving a better surface finish than sharp corners that can grab and tear soft materials.
TiB₂ coating adds wear resistance for longer runs without the aluminum affinity issues that plague AlTiN coatings.
Heat stays manageable, chips evacuate cleanly, and built-up edge formation stays minimal through extended cuts.