200 Series

Tool 200i313X030C

Built-up edge kills aluminum finishes faster than dull cutters. The workpiece welds to the tool, then tears away on the next pass, leaving streaks that look like someone dragged a chisel across the surface. Most shops see this and immediately blame speeds and feeds.

The 200 Series uses three flutes to distribute chip load across more cutting edges while maintaining your programmed feed rate.
Lower chip load per tooth means less heat generation at the cutting zone, which directly prevents the adhesion that creates built-up edge.
TiB₂ coating adds another layer of protection for demanding passes where heat buildup is unavoidable.
The R0.03" corner radius strengthens the cutting edge against chipping while maintaining sharp performance in aluminum, copper, and plastics.
Radius corners handle interrupted cuts better than sharp corners without sacrificing surface finish.