200 Series

Tool 200i625L015C

Built-up edge turns aluminum work into scrap faster than most machinists expect. The material wants to weld itself to the cutting edge, especially when chip load gets too aggressive or evacuation stalls.

This 5/8" diameter cutter runs three flutes to distribute chip load across more cutting edges while maintaining your programmed feed rate.
The math works in your favor.
Lower load per tooth means less heat generation and pressure at each contact point.
TiB₂ coating adds a barrier between carbide and aluminum that resists adhesion better than uncoated tools.
The 0.015" corner radius strengthens the cutting edge against chipping while still providing clean entry into the work.
High helix geometry moves chips out of the cut zone before they can reheat and stick.
Works in aluminum, copper, and plastics where built-up edge is the primary failure mode.