200 Series

Tool 200i625X030C

Aluminum work hardens under the tool nose when you push too hard. Corner breakout, poor surface finish, shortened tool life. It happens when the cutting edge can't maintain its geometry under load. The sharp corner takes the beating first.

The 200i625X030C carries a 0.030" corner radius that distributes cutting forces across more carbide.
Three flutes reduce chip load per tooth compared to 2-flute designs, keeping individual cutting forces lower while maintaining production rates.
The geometry works with aluminum's tendency to work harden rather than fighting it.
TiB₂ coating adds hardness where it matters most.
At the cutting edge.
Without the aluminum affinity issues you get with AlTiN coatings.
Heat stays in the chip, not the workpiece.