200 Series

Tool 200i625X060C

Built-up edge turns a good aluminum job into scrap fast. The material welds to the cutting edge, then tears away, taking tool life and surface finish with it. Heat and pressure are the culprits.

The 200i625X060C addresses this with three flutes instead of two or four.
Lower chip load per tooth reduces heat generation while maintaining productive feed rates.
The TiB₂ coating adds a non-stick barrier that aluminum struggles to adhere to, particularly during demanding passes where cutting forces spike.
The R0.06" corner radius distributes cutting forces across more edge length than a sharp corner.
This prevents the micro-chipping that creates nucleation sites for built-up edge formation.
Works in aluminum, copper, and plastics where adhesion is the primary wear mechanism.