200 Series

Tool 200m050C

The 200m050C is a 5mm 3-flute end mill from the 200 Series, for slotting and side milling in aluminum. Length of cut is 10mm (2x diameter), the stiffest option in the 200 Series at this size.

Three flutes give you more cutting edges than a 2-flute end mill and still leave the chip room aluminum needs.
Sonic designs the flute to clear chips in slotting.
The end is center cutting, so you can ramp and plunge.
A 0.1mm corner radius holds up better than a sharp corner and leaves a 0.1mm fillet where the wall meets the floor.
TiB2 resists aluminum sticking to the edge, so you can run higher speeds and feeds than with an uncoated tool.