910 Series

Tool 910i1212B

Secondary operations add time. A deburr step that takes a minute across 200 parts takes over three hours. The 910 Series is built to eliminate that step.

Single-pass chamfer geometry produces consistent edge breaks across steel, aluminum, and most machinable metals.
The included angle is held to tight tolerances, which matters when chamfer consistency feeds into assembly fit, sealing surfaces, or cosmetic requirements.
The 910i1212B features AlTiN coating for extended tool life in harder steels where heat buildup becomes the limiting factor.
Two flutes balance chip evacuation with strength in the smaller tip diameter.
The 30-degree angle per side handles most standard chamfer requirements while the 0.015-inch tip diameter allows access into tight corners and small features.
Heat resistance from the coating extends cut time between tool changes.
This matters when running production quantities where tool changes interrupt cycle time.