910 Series

Tool 910i1218B

Sharp edges from machining create problems downstream. Parts that should drop into assembly get hung up on burrs. Secondary deburring adds cycle time and labor cost that compounds across production runs.

The 910i1218B eliminates that secondary operation with single-pass chamfer geometry.
The 45-degree angle per side creates consistent edge breaks across steel, aluminum, and most machinable metals.
Two flutes balance surface finish with chip evacuation in the confined space of edge work.
AlTiN coating extends tool life in harder steels where heat buildup typically shortens cutting tool performance.
The 0.015-inch tip diameter handles fine detail work while maintaining the structural integrity needed for production machining.
Angle tolerances are held tight because chamfer consistency affects downstream assembly and sealing surface requirements.