910 Series

Tool 910i1608C

Sharp edges cut operators. Burrs jam assemblies. The 910i1608C eliminates both problems in a single pass.

The 20-degree angle per side creates controlled edge breaks across aluminum and most other non-ferrous metals.
Two flutes balance surface finish with chip evacuation in lighter chamfering cuts.
The 0.02" tip diameter handles tight inside corners and small features where larger chamfer mills cannot reach.
TiB₂ coating extends tool life in abrasive materials.
The coating runs harder than TiAlN while maintaining better lubricity than uncoated carbide.
This combination reduces built-up edge formation on aluminum and extends cut time in work-hardening other non-ferrous alloys.
Consistent chamfer geometry means predictable assembly fits.
No secondary deburring operations.