910 Series

Tool 910i1612B

Sharp edges cut clean but leave burrs. The 910i1612B addresses this with single-pass chamfer geometry that cuts and deburrs simultaneously across steel, aluminum, and most machinable metals.

The 30-degree angle per side produces consistent edge breaks without requiring secondary operations.
Two flutes balance surface finish with chip evacuation in the small 0.02-inch tip diameter.
AlTiN coating extends tool life in harder steels where heat buildup typically shortens cutting tool performance.
Tight tolerance control on the included angle matters when chamfer consistency affects downstream assembly or sealing surfaces.
The geometry eliminates the variability that comes from separate deburring steps while maintaining the edge break specifications your prints require.