910 Series

Tool 910i2008C

Sharp corners chip. A 0.025" tip diameter removes just enough material for a clean edge break without overloading the tool geometry.

The 20-degree angle per side cuts efficiently across steel and aluminum while maintaining the structural integrity needed for consistent chamfers in production runs.
Three flutes balance surface finish with chip evacuation.
Critical when you're removing small amounts of material where chips can pack and cause surface defects.
TiB₂ coating extends tool life in abrasive materials.
The coating's hardness properties work particularly well in steel applications where heat buildup can degrade edge quality over time.
The single-pass geometry eliminates secondary deburring operations that add cycle time and handling steps.
Works across steel, aluminum, and most machinable metals without geometry changes.