910 Series

Tool 910i2406C

Secondary operations add time. A deburr step that takes a minute across 200 parts takes over three hours. The 910 Series is built to eliminate that step.

Single-pass chamfer geometry produces consistent edge breaks across steel, aluminum, and most machinable metals.
The included angle is held to tight tolerances, which matters when chamfer consistency feeds into assembly fit, sealing surfaces, or cosmetic requirements.
The 910i2406C runs a 15-degree angle per side with three flutes.
TiB₂ coating extends tool life in harder steels where heat buildup becomes the limiting factor.
The 0.03-inch tip diameter handles fine detail work where larger chamfer mills create overcutting issues.
Three flutes balance surface finish against chip evacuation.
More flutes would pack chips in tight corners.
Fewer would leave tool marks on critical surfaces.