910 Series

Tool 910i2418B

Sharp corners tear out. Burrs form. The deburr station becomes a bottleneck when every part needs hand finishing.

The 910i2418B cuts clean 45-degree chamfers in a single pass, eliminating the secondary deburr operation that typically follows drilling or milling.
Three flutes balance surface finish with chip evacuation across varying feed rates.
The AlTiN coating extends tool life in steel applications where heat buildup would otherwise limit cutting speeds.
The 0.03" tip diameter accesses tight spaces while maintaining the structural integrity needed for consistent angle geometry.
This matters when chamfer uniformity affects downstream assembly operations or surface requirements.
Single-pass chamfer geometry works across steel, aluminum, and most machinable metals.
The 45-degree included angle is held to tight tolerances.