940 Series

Tool 941i1212C

When you're engraving serial numbers on titanium aerospace components or marking hardened steel tooling, standard engravers dull fast. The material fights back, and tip wear shows up as inconsistent mark depth within the same lot.

The 941i1212C addresses this with a 0.012" tip diameter and 60-degree included angle optimized for fine detail work.
The geometry concentrates cutting force at a precise point while maintaining structural integrity through the tip.
TiB₂ coating adds hardness and thermal stability when marking abrasive composites and heat-resistant alloys where uncoated carbide struggles.
Single flute design clears chips effectively in short engagement marking operations.
Works across metals and composites where traceability marking demands consistent depth control and clean edge definition.