940 Series

Tool 942i0808B

When marking thin-wall components or creating fine detail work, standard engravers often cut too wide or chip out on entry. Precision suffers.

The 942i0808B uses a 0.008-inch tip diameter for controlled mark width in delicate operations.
The 90-degree included angle provides the right balance of strength and penetration for general marking applications across metals and composites.
AlTiN coating extends tool life in harder alloys where uncoated carbide would wear rapidly, particularly useful when marking stainless steels or titanium components where heat buildup accelerates wear.
Single-flute geometry clears chips effectively during plunge operations and maintains the sharp edge definition required for readable marks.
Works well for serial numbers, part codes, and decorative V-grooving where mark consistency matters more than speed.