940 Series

Tool 941i1604C

When marking thin-film coatings or delicate substrates, standard engravers can tear material instead of cutting it. The cutting edge loads up, the mark becomes inconsistent, and you're looking at scrap parts.

The 941i1604C addresses this with a 0.004" tip diameter and 60-degree included angle that concentrates cutting forces into a precise point.
The TiB₂ coating runs harder than standard carbide while maintaining a sharp edge geometry that won't pull or tear composite matrices during marking operations.
Single flute design evacuates chips cleanly in the narrow groove width this tip produces.
Built for metals and composites where mark quality determines part acceptance.
Depth consistency holds across production runs because the tip geometry stays stable under the concentrated loads these small contact areas generate.